THEN you can primer it. What you want to do would make for way to much product on the car and it would chip easily and just make fior a shitty overall and would not last long at all. then apply your paint over your primer which you will want to sand with 320 to 400 but if you use 320 you will ... You always hope that the metalwork will get done and that the body filling part of the job will require about a teaspoon of Bondo, preferably less. It rarely actually ends up that way, and I doubt it ever ends up that way with a job the size of the one that we were doing on this old bonnet.
without it the bondo will never get hard. put a lil glob of bondo on a board and run a line of hardener over the top from end to end. mix it up and apply, it should give you about five minutes working time before it starts to harden. once it starts tacking up, stop […] Dec 01, 2009 · Don't know about putting red oxide over in but epoxy primer but I will tell you epoxy primer is some good stuff. It's not cheap but is tough as nails. I used to use it all the time on old tractors. It will also fill small imperfections. I have a feeling what you are wanting to do will work but you will loose some of the qualities of the epoxy.
Tomb of annihilation azaka
Orzhov budget deck
Flir e4 hack
Dream of someone lying on your back